- #Star system obd2 reader w210 drivers#
- #Star system obd2 reader w210 registration#
- #Star system obd2 reader w210 code#
Performing the drive cycle on the vehicle will take up to 1 1/2 hours.Ĥ. On-Board Diagnostic System (OBDII) used on the vehicle, are ME1.0, ME2.0 or ME2.1 systems.ģ. A drive cycle has been developed for the following model years and models: Immediately to an I/M station for emission testing.Ĭycling the ignition key from on – to – off prior to performing the I/M test is not recommended.ġ. In such a case, the customer should be notified and instructed not to take the vehicle
#Star system obd2 reader w210 registration#
Vehicle is immediately taken from the service facility to an I/M testing facility for vehicle registration check engine light NOT on) then a drive cycle test must be performed on theĪ battery disconnect to service the vehicle can impact whether the readiness codes will be set, if the If a model year 1996 through 1999 vehicle has “failed” a State I/M emission test and no faults have beenįound in the system (i.e. In an effort to prevent this situation from happening, a specificĭrive cycle must be performed prior to the vehicle being tested at any I/M facility checking the OBDII Without theseĬodes set, the vehicle will most likely fail the emissions portion of this inspection and the customer will notīe able to register or re-register their vehicle. These readiness codes are needed to be set (complete) within the OBDII computer system. Use hand held scan tools capable of reading OBDII codes and will indicate if these readiness codes are set The vehicles computer to indicate if the system is “ready” to be emission tested. The OBDII system uses readiness codes built into Or not the vehicle’s OBDII system is “ready” to be tested. These State I/M facilities will specifically look for whether Is required for customers to register their vehicles. Refer to Service Information: P-SI-14.00/14 for historical information.Ĭertain States around the country have or will begin to roll-out in the coming months, OBDII (On-Boardĭiagnostic II) quick checks for emission inspection and maintenance (I/M) testing. Models, Model Years & OBDII Systems Included Description of State I/M OBDII Checks & Drive Cycleī. SUBJECT: State I/M (emission inspection and maintenance) Facilities Incorporating an OBDII CheckĪ.
Mercedes Benz Service Bulletin (S-B-14.00/17) He had already driven hundreds of miles and still the catalyst monitor was incomplete. Our customer had a stubborn CATALYST MONITOR on his 2002 Benz. He stated that this procedure completed the AIR readiness monitor. He then turned off his vehicle and restarted the vehicle the next morning and allowed it to idle for another 5-10 minutes. We located a Mercedes Benz Service Bulletin (S-B-14.00/17) that may be helpful.Īlso, one customer with a 2002 Mercedes was unable to complete the secondary air injection monitor until one evening he allowed his vehicle to idle for 5-20 minutes in his driveway. The two readiness monitors that seem to be the most stubborn to complete are: Secondary Air Injection and Catalyst (Catalytic Converter).
#Star system obd2 reader w210 drivers#
Get the OTC 9450 to help you fix it right the first time.Many drivers have had difficulty completing readiness monitors for their Mercedes Benz.
#Star system obd2 reader w210 code#
The OTC 9450 (Bilingual OBD2 Scanner, ABS Code Reader, and Airbag/SRS Code Reader) quickly and accurately diagnoses the cause of the check engine, ABS and SRS airbag malfunction indicator lights. Take the guesswork out of engine, ABS, and Airbag (SRS) repairs.
0 kommentar(er)
